Difference between revisions of "PowDeR/RF Power Devices"

From Web
Jump to navigation Jump to search
Line 12: Line 12:
  
 
The system consists of a cascade of three amplifier modules, Amp1, Amp2 and PA, as shown in Fig.1.
 
The system consists of a cascade of three amplifier modules, Amp1, Amp2 and PA, as shown in Fig.1.
[[File:schblk_en.jpg|200px|thumb|left|Fig.1. Block diagram of the 10GHz power amplifier]]
+
[[File:schblk_en.jpg|300px|thumb|left|Fig.1. Block diagram of the 10GHz power amplifier]]

Revision as of 13:59, 24 June 2010

10 GHz RF Power Amplifier for Continuous Wave Load Pull measurements


Introduction

We developed a custom rackmount amplifier capable of delivering a RF continuous power of 8W on a 50W load at a nominal frequency of 10GHz. The amplifier has been integrated into an existing on-wafer 2GHz CW RF Load Pull measurement system, thus extending its performace capabilities to the frequency of 10GHz , and is based on commercial amplifier modules, all manufactured by Kuhne Electronic GmbH, Germany, [1].


System description

The system consists of a cascade of three amplifier modules, Amp1, Amp2 and PA, as shown in Fig.1.

Fig.1. Block diagram of the 10GHz power amplifier